-
Recent Posts
Archives
- November 2021
- March 2021
- June 2020
- December 2019
- December 2018
- February 2018
- May 2017
- February 2017
- November 2016
- October 2016
- June 2016
- May 2016
- January 2016
- August 2015
- May 2015
- January 2015
- October 2014
- June 2014
- March 2014
- February 2014
- July 2013
- May 2013
- March 2013
- October 2012
- September 2012
- August 2012
- July 2012
Categories
- Annealing
- Books
- Borax
- Borax bead test
- Borax glaze
- Bubbles
- Cartoon design
- CMC
- Copper-foiled
- Cutter Oil
- Cutting Oil
- Devitrification
- Dichroic Glass
- Drilling holes
- Engraved Glass
- Etched Glass
- Experiment
- Flux
- Frit
- Frit Sifting
- Glass Cleaning
- Glass Cutter
- Glassline Paper
- Glassline Pen
- Glastac
- High temperature wire
- Inclusions
- kiln controller
- kiln schedule
- Lead cutter
- leaded light
- Leaded light cement
- Liquid Stringer
- Lubricant
- Melting Glass
- Microwave kiln
- Microwaved metal
- Money-saving ideas
- Mould
- Patina
- Plant materials
- Polishing
- Putty
- Recycling
- Repair
- Sagging
- Solder
- Soldering
- Stringer
- tallow
- temperature curve
- Tylo
- Uncategorized
- Whiting
- Wired beads
Meta
Category Archives: Solder
Traditional Leaded Light Construction
It’s not often that I construct a leaded light but having done so recently I thought I should share some notes with you. They may help you as a newcomer or give you some new ideas if it’s an activity … Continue reading
Posted in Cartoon design, Flux, Glass Cutter, Lead cutter, leaded light, Leaded light cement, Putty, Solder, Soldering, tallow, Whiting
Tagged AllNova Tool, Cartoon, Cement, flux, lead, Lead cames, Lead cutter, leaded light, Leaded light cement, Oyster Tool, Putty, solder, soldering, Stretch, tallow, Whiting
4 Comments
Which Solder Should I Use?
There are several kinds of solder available for stained glass work. Are you always using the right kind? There’s a lot of good advice and information on the Internet. There’s also a lot that isn’t. That’s the trouble with the … Continue reading
You must be logged in to post a comment.